Home > > Wind generators news > > Hybrid renewable energy system
FATRONIK technological centre from the Basque Country has designed and installed a micro-wind generator at the Aubixa Euskal Girotze boarding centre (San Pedro neighbourhood, Elgoibar). Since the end of October the 2.5 kW micro-wind generator has been producing energy which is initially planned to power the boarding centre¡¯s four refrigerators, the control room, the data-reception sensors and the PCs. Moreover, four 120 kW photovoltaic plates have been incorporated into the micro-wind generator, thus generating a hybrid system which takes maximum advantage of renewable resources such as the sun and the wind.
The triple-bladed wind generator rotor was designed by the Australian company Bolwell Corporation. Each vane is 2.1m long with an aerodynamic profile chosen for working with low Reynolds values - they have a variable angle of torsion running from the base to the tip. In this way, the angle of attack of the wind with respect to the vane is kept constant all along its length. The rotor is directly coupled to a multipolar electric generator consisting of permanent magnets (PMG) with no intermediate multiplier. The current generated is alternating and with variable voltage and frequency. This current goes to a number of batteries after passing through a voltage regulator which converts the alternating current to direct and eliminates the surplus voltage. Finally, the current is converted into one at 220V with a current inverter, thus adapting the voltage for customary usage.
The wind generator starts to rotate at wind speeds of 3.5m/s and reaches maximum power at 9.5m/s. If the wind exceeds a velocity of 16m/s the passive power control system (side furling) of the wind generator comes automatically into operation: this control system is achieved through an articulated assembly between passive power regulation system and the body of the wind generator which is situated eccentrically to the axis of the wind generator¡¯s truss tower. Thanks to this braking mechanism for the rotor, both the electric surge infrastructure and the mechanical components are protected against excessive centrifugal forces.
This hybrid system is designed to work autonomously, i.e. outside the electric grid system. So, this kind of application is of great use in communities distant from cities or towns such as rural areas or zones under development. These systems can be used as a substitute for the grid in areas where the latter system is prohibitively expensive and, moreover, they promote awareness regarding natural resources.
If they are compared to high-powered wind generators, the main difference is in the simple: easy installation and maintenance, minimum aesthetic impact and totally integrable into the environment.
Related Questions:
1. Vice premier calls for public participation in saving energy
2. China to amend law to reduce energy consumption
3. China ready to introduce fuel tax
4. Researchers make advances in wind energy generation
5. Avenir Energie's Geopack pumps up the energy
7. Drought Solution Could Be Blowing In The Wind
8. Winds of 320 000 kilometres per hour on the Sun
10. Renewable energy wrecks environment
11. Solar Energy: Electricity Out Of A Helicopter Turbine
12. Mountain winds may create atmospheric hotspots
13. Research expedition braves world's worst weather
14. wind energy on a chip promises to best the battery
15. Pollen proves beneficial for northern lakes
16. 1 of deep ocean's most turbulent areas has big impact on climate
17. Microwaving trees speeds up coffee table production
18. XMM-Newton's anniversary view of supernova SN 1987A
19. Lightning research sparks new discovery
20. Hybrid renewable energy system
