The cabin: the cabin inclusive of the key wind turbine equipment, including gear boxes, generators. Maintenance personnel can wind turbine tower into the cabin. The cabin extreme left is the wind turbine rotor, rotor blades and shaft.

       Rotor blades: Zhuohuo wind, and wind sent to the axis of the rotor. Modern 600 kilowatt wind turbines, each measuring the length of the rotor blades about 20 meters, and has been designed as aircraft wings.

        Axis: rotor axis wind turbine attached to the low-speed shaft.

       Low-speed shaft: the low-speed wind turbine rotor shaft axis will be linked with the gear box. In the modern 600 kilowatt wind turbine, the rotor speed is slow, about 19-30 minutes to each. Axis in the catheter used in the hydraulic system, to stimulate the operation of air power gate.

       Gearbox: the left is a low-speed gear box shaft, it could be the high-speed shaft rotational speed increased to 50 times the low-speed shaft.

       High-speed shaft and mechanical gate: high-speed shaft to 1,500 per minute to operate and drive generators. It is equipped with a mechanical emergency gate, the gateway for air power failure, or the wind turbine was maintenance.

       Generator: often referred to as asynchronous induction motor or generator. In the modern wind turbine, the largest power output is usually 500 to 1,500 kilowatts.

       Yaw devices: With motor rotating cabin, so that the rotor facing the wind. Yaw by the electronic device controller operation, the electronic controller can leader to feel the wind direction. Map shows that the wind turbine yaw. Usually, the wind changed its direction, the wind turbine only a deflection on several occasions.

       Electronic Controller: contains a constant state of the wind turbine control computer, and yaw control devices. In order to prevent any fault (that is, gear box or generator overheated), the controller can automatically stop the rotating wind turbine and by telephone modem to call the wind turbine operators.

       Hydraulic system: for replacement of the air force wind turbine gate.

       Cooling components: contains a fan for cooling generators. In addition, it includes an oil cooling components, gear boxes used for cooling the oil. A number of wind turbine generators with water.

       Tower: wind turbine towers containing the cabin and the rotor. Usually high tower has advantages because of the higher from the ground, the greater the wind speed. Modern 600 kilowatt wind turbine towers high for the 40 to 60 meters. It is tubular tower, it can also be a lattice-shaped tower. Tubular towers for the maintenance staff of more security, because they can reach the top of the tower within the ladder. Lattice-like towers of the advantages is that it is cheaper.

       Anemometer and leader: used to measure wind speed and wind generators direction